			     Core Wars Deluxe v1.3
-------------------------------------------------------------------------------

The assembler provided with the Core Wars Deluxe program was designed to be
as up-to-date and as forgiving as possible.  I am afraid that not everything
has been completely written for it yet, but I intend to finish it before the
next release.

Here is a list of features and short comings the assembler has:

  1)  Labels may be of any length and are case sensitive.  Any colon that
	follows a label will be ignored.

  2)  Fields may optionally be seperated by commas.  I highly recommend
	there use, for reasons that I will describe.  Since fields may 
	actually be made up of expressions, it is possible that the B-field
	could be incorporated into the expression, whether you intend it
	to be or not.  For example: "mov #0 -1" would be interpreted as
	"mov #-1 #0" and "mov -1 -1" would be interpreted as "mov -2 #0".
	In these cases, use "mov #0,-1" and "mov -1,-1" instead.

  3)  Expressions are still not handled to the full specifications of the
	standards.  All labels are converted to their proper addresses, 
	and figured into the expressions.   All expressions are calculated
	from left to right, and no order of precendence exists.  You may
	use the +-*/ operators and parenthesis are not supported.  All 
	division is integer division.  So, keep in mind that "1+3*2" is
	currently calculated as "8" and not "7".  I will correct this in 
	a future version of the program.

  4)  The standards also specify the use of the EQU compiler directive.
	I have included it as a future expansion to my assembler, but is
	not currently supported in Redcode programming.  I will include it
	in a future version of the program.

  5)  The END compiler directive is also supported.  At the end of your 
	Redcode program, include the line "END <label>", such as "END start",
	and the loader will automatically flag that line specified as the
	starting point of the program.  If you specify the END statement
	without a label, then the first line of the program is the starting
	point of the program.  If you do not specify the END statement at
	all, then the same also happens, the first line of the program is
	the starting point of the program.

  6)  All instructions are non-case sensitive.

  7)  Any B-field left blank is automatically filled in with a "#0".

  8)  Comments may be included, and must start with a semicolon (";").
	Anything following the semicolon is ignored.  Blank lines are also
	allowed and is ignored.

  9)  The ICWS-88 Standards are followed as closely as possible.  This does
	mean that "DAT" instructions are not allowed to have modes of type
	direct (" ") or indirect ("@").  This may cause problems with any
	program originally written using the ICWS-86 standard.  Another 
	instruction that is notably changed from the old standard is the 
	"CMP" instruction.  The '86 Standard allows immediate operands in
	the B-field, but not in the '88 Standard.  To correct this, just 
	switch the A-field and B-field around, and it will work properly.
